Bnc 835-3 User Manual Manual de usuario descargar pdf (Pagina 6)

Amplitude - The current value for output power. Units: dBm

Range: -70.0 to +25.0 dBm (option PE/PE2: -150.0 to + 25 dBm)

Resolution 0.1 dB

Phase lock – External reference disabled, not locked or locked to integer multiple of 1 MHz

Range: 1 to 100 MHz

LAN – The current IP address of the instrument

Rear Panel Connections

Figure 2 835-3 Rear Panel View

1 Power switch The power switch disconnects the signal generator from the DC input

completely, including the internal high-stability reference. After switching on this switch,

the signal generator enters into standby with the OCXO warming up and RF out switched

off. The red power LED (option HC only) on the front panel is turned on.

2 DC IN power receptacle The power receptacle accepts a two-pin plug from the external

6 V DC power adapter

3 RJ-45 host connector Used for connecting with a controller, such as a PC or Labtop.

4 FM/PM MOD IN connector This BNC input connector accepts a 0 to 2 V (peak) signal for

FM modulation. The damage level is 4 Vrms.

5 REF IN connector Female BNC connector, accepts a TTL or -5 to +15 dBm sine signal

from an external reference oscillator that is within ±1 ppm of the programmed reference

frequency. The nominal input impedance is 50 ohm.

1 2 3 4 5 6 7 8 9 10 11 ... 41 42

Sin comentarios

Bnc 835-3 User Manual Manual de usuario Pagina 6