Bnc 835-3 Programmer Manual Manual de usuario descargar pdf (Pagina 24)

Berkeley Nucleonics

www.Berkeley Nucleonics.com

835-3

Programmer’s Manual v1.0

Page 24 of 37

The variable <value> is expressed in units of Hertz.

The setting enabled by this command is not affected by signal generator power- on,

preset, or *RST.

Range Please refer to the Data Sheet.

:LIST:MANual

[SOURce]:LIST:MANual <value>|UP|DOWN

[SOURce]:LIST:MANual?

This command sets a list or step sweep point as the current sweep point controlling the

frequency and power output. If list or step mode is controlling frequency or power, or

both, then the indexed point in the respective list(s) will be used.

Entering a value with this command will have no effect, unless MANual is the selected

mode. Refer to :LIST:MODE command for setting the proper mode.

If the point selected is beyond the length of the longest enabled list, then the point will

be set to the maximum possible point, and an error will be generated.

Range 1–3’501

:LIST:MODE

[SOURce]:LIST:MODE AUTO|MANual

[SOURce]:LIST:MODE?

This command sets the operating mode for the current list or step sweep.

AUTO This choice enables the selected sweep type to perform a sweep of all

points.

MANual This choice enables you to select a single sweep point. The selected point

controls the frequency and/or amplitude according to the sweep type.

Refer to :LIST:MANual command for selecting a sweep point.

*RST AUTO

:LIST:POWer

[SOURce]:LIST:POWer <value>{,<value>}

[SOURce]:LIST:POWer?

This command sets the amplitude for the current list sweep points.

:LIST:POWer:POINts

[SOURce]:LIST:POWer:POINts?

This command queries the number of power points in the current list sweep file.

:LIST:COUNt

[SOURce]:LIST:COUNt <value>

[SOURce]:LIST:COUNt?

This command sets the number of consecutive times the list is executed on each sweep

start.

The variable <value> is 1 to 65635 or INFinity.

[SOURce]:LFOutput Subsystem

Command Parameters

Unit

(default)

[SOURce]:LFOutput:AMPLitude <value>

1 V

[SOURce]:LFOutput:FREQuency <value>

400 Hz

[SOURce]:LFOutput:STATe ON|OFF|1|0

OFF

[SOURce]:LFOutput:SHAPe SINE|TRIangle|SQUare

SINE

[SOURce]:LFOutput:SOURce LFGenerator|PULM|TRIGger

LFG

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

Comentarios a estos manuales

Sin comentarios

Bnc 835-3 Programmer Manual Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Bnc 835-3 Programmer Manual