Bnc 835-3 Programmer Manual Manual de usuario descargar pdf (Pagina 31)

Berkeley Nucleonics

www.Berkeley Nucleonics.com

835-3

Programmer’s Manual v1.0

Page 31 of 37

• GATE : trigger level starts/stops sweep

2. Setting the waveform’s response to triggers:

— CONTinuous : reapeatedly accepts trigger events

— SINGle : uses only one trigger event

3. Selecting the trigger source which determines how the BNC MODEL 835-3 receives its

trigger signal, internally or externally. The GATE choice requires an external trigger.

3. Setting the trigger polarity when using an external source

Command Parameters

Unit

(default)

[SOURce]:TRIGger[:SEQuence]:TYPE NORMal | GATE | POINT

[SOURce]:TRIGger[:SEQuence]:TYPE:GATE

LOW|HIGH HIGH

[SOURce]:TRIGger[:SEQuence]:SOURce IMMediate|KEY|EXT|BUS IMM

[SOURce]:TRIGger[:SEQuence]:DELay

<value>

[SOURce]:TRIGger[SEQuence]:SLOPe

POSitive|NEGative POS

[SOURce]:RETRigger

ON|OFF|IMMediate

Not

impleme

nted

[SOURce]:TRIGger[:SEQuence]:ECOunt

<value> 1

:TRIGger:TYPE

[SOURce]:TRIGger:TYPE NORMal | GATE | POINT

[SOURce]:TRIGger:TYPE?

This command sets the trigger type that controls the waveform’s playback.

The following list describes the trigger type command choices:

NORMal Upon triggering, the waveform sequence plays according to

settlings defined by :INITiate:CONTinuous (only once or repeatedly)

GATE An external trigger signal repeatedly starts and stops the

waveform’s playback. The time duration for playback depends on

the duty period of the trigger signal and the gate polarity selection.

The waveform plays during the inactive state and stops during the

active polarity selection state. The active state can be set high or

low. The gate mode works only with an external trigger source.

POINT Upon triggering, only a single point of the sweep (list) is played.

*RST NORM

:TRIGger:TYPE:GATE

[SOURce]:TRIGger:TYPE:GATE LOW|HIGH

[SOURce]:TRIGger:TYPE:GATE?

This command selects the active state (gate polarity) of the gate while using the gating

trigger mode. The LOW and HIGH selections correspond to the low and high states of an

external trigger signal. For example, when you select HIGH, the active state occurs

during the high of the trigger signal.

When the active state occurs, the BNC MODEL 835-3 starts the waveform playback at the

last played sample point, then stops the playback at the next sample point when the

inactive state occurs.

LOW The waveform playback starts when the trigger signal goes low (active

state) and stops when the trigger signal goes high (inactive state).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Comentarios a estos manuales

Sin comentarios

Bnc 835-3 Programmer Manual Manual de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Bnc 835-3 Programmer Manual