Bnc 835 Programmer Manual Manual de usuario descargar pdf (Pagina 14)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901

Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com

3.1.7 *OPT?

The options (OPT) query returns a comma-separated list of all currently installed instrument options on

the signal generator.

Returned option strings are:

0 Basic device

B3 Rechargeable battery pack

PE|PE2|PE3 Extended power range

AVIO ILS and VOR modulations

GPIB GPIB (IEEE 488) programming interface

3.1.8 *RCL <reg>

The Recall (RCL) command recalls the state from the specified memory register <reg>.

3.1.9 *RST

The Reset (RST) command resets most signal generator functions to factory- defined conditions.

Remarks Each command shows the [*RST] default value if the setting is affected.

3.1.10 *SAV <reg>

The Save (SAV) command saves signal generator settings to the specified memory register <reg>.

Remarks The save function does not save all signal generator settings. Refer to the User’s Guide for

more information on the save function.

3.1.11 *SRE <data>

The Service Request Enable (SRE) command sets the value of the Service Request Enable Register.

The variable <data> is the decimal sum of the bits that will be enabled. Bit 6 (value 64) is ignored and

cannot be set by this command.

Range 0–255

The setting enabled by this command is not affected by signal generator preset or

*RST. However, cycling the signal generator power will reset it to zero.

3.1.12 *SRE?

The Service Request Enable (SRE) query returns the value of the Service Request Enable Register.

Range 0–63 & 128-191

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 64 65

Sin comentarios

Bnc 835 Programmer Manual Manual de usuario Pagina 14