Bnc SAM 935 Portable Gamma Spectroscopy System Manual de usuario descargar pdf (Pagina 52)

48 SAM 935™ Instruction Manual

6.3.1 Adding a New Isotope

To add a new isotope, press ADD (F2). A new entry will be

added at the bottom of the list. Then use the E

DIT and ENABLE

functions as described next to give the isotope the name and

parameters desired.

6.3.2 Enable/Disable Isotopes

Only those isotopes that are “enabled” are considered in searches and quantitative analysis. To enable an

isotope, select it in the list with the arrow keys and press E

NABLE (F3). An enabled isotope may be disabled

by selecting it and pressing the D

ISABLE (F3) key. Note that the label on F3 indicates what state the

selected isotope would change to if you pressed it.

Enable/Disable Isotopes applies only to the Manual MCA mode. See Section 6.1.2 “Select Trigger” to

select isotopes for the Monitor and Surveillance operating modes.

6.3.3 Editing an Isotope

Press EDIT (F4) to edit the isotope information:

1. First the name is edited:

2. Edit the value of the half-life:

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 69 70

Sin comentarios

Bnc SAM 935 Portable Gamma Spectroscopy System Manual de usuario Pagina 52