Bnc SAM 935 Portable Gamma Spectroscopy System Manual de usuario descargar pdf (Pagina 57)

SAM 935™ Instruction Manual 53

• The maximum uncertainty value (default 1.0) will

require that a peak's counts be at least

times higher

than the counting uncertainty before that peak will be

used in matching. This is useful for discarding

low-count rate peaks from noisy spectra. A value of 0

means that all peaks will be accepted. The factory-set

default value is 1.000.

• The energy match window parameters A and B define

a tolerance of +/-(A+Bx) in terms of the energy of the

measured peak. Any isotope lines falling inside this

window can be considered in the peak identification

process; any others will not be considered. The default

for window A is 8.000 keV; the default for window B is

0.0550 keV.

• After all other setup information has been edited, you may enter 3 fine calibration quadratic coeffi-

cients if needed. Each one will be presented in a separate display.

6.9 Select Spectrum Draw Style

The SAM 935 can display spectral data using points, lines, or filled (bar) mode. You can select how the

main body of the spectrum will be displayed and how ROI regions will be displayed. Experiment with vari-

ous combinations to find the display you like best.

6.10 Show System Information

The show system information screen displays the model, software version number, and serial number of

the device. This information is very important in the diagnosis of any problems that might occur with your

system. In addition, it will show you the current baud rate setting for your communication port.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

Sin comentarios

Bnc SAM 935 Portable Gamma Spectroscopy System Manual de usuario Pagina 57