BNC 575 Series Especificaciones descargar pdf (Pagina 17)

6-17

Mode Menu

Channel Enable

Mode: Normal

Mode: Single

Shot

Mode: Burst

Mode:

Duty Cycle

#/On Pulses

#/Burst Pulses

#/Off Pulses

Wait Menu

Channel Enable

#/Wait Pulses

Enabling Channel Output

At the top of each of the channel menu pages is a parameter to enable or disable

the channel. Each channel may be individually controlled. When enabled, the

channel key will illuminate.

Setting the Channel Timing Parameters

To define a pulse requires two parameters: the delay to the active edge and the

width of the pulse.

Wid: Sets the channel pulse width.

Dly: Sets the channel delay until the active edge.

Setting Pulse Configuration Output Type

The 575 supports two types of outputs: a high speed TTL/CMOS compatible

output and for applications which require different voltage levels or higher

cur-rent, an adjustable voltage output. The pulses can also be defined to be

active high or active low.

Out: Selects the output mode; TTL/CMOS, Adjustable, Optical,

High Impedance (Hi Z), or Low Impedance (Lo Z)

Pol: Sets the pulse polarity, active high or active low.

Ampl: Sets the output voltage level when in the Adjustable mode.

Setting Channel Mode of Operation

Each channel may be set independently to operate in one of four modes: normal,

single shot, burst, or duty cycle (within the CHANNEL menus):

Mode: Selects the mode for the current channel. Additional

parameters are provided for the burst mode and the duty

cycle mode.

Brst: Sets the number of pulses in the burst mode to gener-ate

before inhibiting output.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 62 63

Sin comentarios

BNC 575 Series Especificaciones Pagina 17