Bnc 1201 - 6 1/2 Digit Digital Multimeter Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 177
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
45
Press SHIFT + TEMP buttons.
Take the reading on the display.
Figure 3-12
3.7.2 RTD Measurements
There are three kinds of temperature measurements with RTDs: 2-wire,
3-wire and 4-wire measurements. You will find connection instructions
and measuring procedures in the following sections.
3.7.2.1 2-Wire RTD Measurements
How to measure temperature with 2-Wire RTD
The following Figure 3-13 shows theory diagram of 2-Wire RTD
measurement.
Use terminals switch to select front terminals.
Insert a specified adapter into the front terminals. Connect the low
thermal patch leads to the adapter as shown in Figure 3-14.
Configure sensor type and unit using CONFIG + TEMP and or .
When ready, press ENTER button.
Press TEMP button.
Place RTD in the desired position and take the reading on the display.
3
5
4
1
2
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 176 177

Comentarios a estos manuales

Sin comentarios