Bnc 1105 Universal Counter Manual de usuario descargar pdf (Pagina 148)

148

148148

148

Internal 1 is used.

 This command does not apply on Rise/Fall time, Duty cycle or Pulse width

measurements.

[:SENSe]:TINTerval:ARM:ESTARt[:LAYer[1]]:SOURce IMMediate TIMer

INTernal[1]

Sets or queries the start arm delay fro Time Interval measurements.

Return

 A sequence of ASCII-encoded bytes. IMM means Immediate, TIM means Timer and

INT means Internal.

Note

 This will be set to Immediate after the counter has been turned off or a remote

interface reset.

 This command does not apply on Rise/Fall time, Pulse width or Duty Cycle

measurements.

[:SENSe]:TINTerval:ARM:ESTART[:Layer[1]]:TIMer <numeric value> [S]

Sets or queries the delay time in start arm for Time Interval measurements.

Return

 Numeric data transferred as ASCII bytes in <NR1> format.

Notes

 This will be set to 100E-9 seconds after the counter has been turned off or a remote

interface reset.

 This command only applies when [:SENSe]:TINT:ARM:ESTART[:LAYer[1]]:SOUR

TIM is used.

 This command dos not apply on Rise/Fall time, Pulse width or Duty cycle

measurements.

[:SENSe]:TINTerval:ARM:ESTOP:LAYer2:SLOPe POSitive NEGative

Sets or queries the slope of the external stop arm signal used in external arming Time

interval measurements.

Return

 A sequence of ASCII-encoded bytes. POS means Positive edge and NEG means

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 196 197

Sin comentarios

Bnc 1105 Universal Counter Manual de usuario Pagina 148