Bnc 1105 Universal Counter Manual de usuario descargar pdf (Pagina 55)

5555

LOW, MED (medium) and HIGH as shown in the Figure 4-21.

Figure 4-21

 To set Com.: The setting is enabled only by using Time Interval as

shown in the Figure 4.22. To toggle the softkey Com. OFF, sources

will be inputted to the CH1 and CH2 individually as the Time Interval

is working. To toggle the softkey Com. ON, sources will be supported

via CH1 only as the Time Interval is working.

Remote Interface Command

To turn on/off auto triggering

[:SENSe]:EVENt[1|2]:LEVel[:ABSolute]:AUTO ON|OFF

To set trigger level

[:SENSe]:EVENt[1|2]:LEVel[:ABSolute] <numeric value> [v]

[:SENSe]:EVENt[1|2]:LEVel:RELative<numeric value> [PCT]

To set sensitivity

[:SENSe]:EVENt[1|2]:HYSTeresis:RELative 100|50|0

To specify triggering slope/edge

[:SENSe]:EVENt[1|2]:SLOPe POSitive|NEGative

To set common

[:SENSe]:EVENt2:FEED “[:]INPut[1] | [:]INPut2”

Using Com. to Make Time Interval (TI) Measurement on a Single

Signal

As described in Ch.3.3, Interval 1 to 2 measures the length of the

duration between a start event on channel 1 and a stop event on channel

2. And users also can do the settings on level, slope or sensitivity for

application purposes. One may also follow the following instructions such

that the start and the stop events are triggered from the same source

connected to one of the two channels:

1. Connect a signal source to channel 1 (or 2).

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 196 197

Sin comentarios

Bnc 1105 Universal Counter Manual de usuario Pagina 55