
Figure 5-1
Note: The Pass/Fail Output can’t be used on Volt Peak and Totalize.
5.2 Pass/Fail Output via DB9 Connector
The DB9 connector is an optional accessory for another kind of Pass/Fail
solutions. With the connector assistance, and by the setting set to DB9
according to the similar operation procedure in the Chapter 5.1, the DB9
will output +12V via Pin4 as the limit test is passed, and the DB9 will
output -12V via Pin4 as the limit test is failed. Figure 5-2 shows the DB9
connector.
4 Output
Measurement In-Limit Signal
All other pins:no connection
Figure 5-2
Note: The Pass/Fail Output can’t be used on Volt Peak and
Totalize.
5.3 Setting Up for Remote Access
Users may use the MODEL 1105 application developed by BERKELEY
Comentarios a estos manuales