Bnc 1105 Universal Counter Manual de usuario descargar pdf (Pagina 73)

7373

[:VOLTage]:PWIDth [<reference>][,(@1)]

[:VOLTage]:NWIDth [<reference>][,(@1)]

[:VOLTage]:INITerval [(@1),(@2)]

[:VOLTage]:PTPeak [(@1),(@2)]

[:VOLTage]:MAXimum [(@1),(@2)]

[:VOLTage]:MINimum [(@1),(@2)]

[:VOLTage]:CENTer [(@1),(@2)]

[:VOLTage]:PHASe [(@1),(@2)]

[:VOLTage]:DCYCle [<reference>][,(@1)]

[:VOLTage]:PDUTycycle [<reference>][,(@1)]

[:VOLTage]:TOTalize:CONTinuous [(@1)]

[:VOLTage]:TOTalize:TIMed [<gate_time>][,(@1)]

The READ? Command

The command READ? is often used with the command CONFigure? to

have a effect similar to the command MEASure? in which the users

provide required parameters, configure the counter and make

measurements. The command :CONFigure? does the configuration part

of the measurement, and the command :READ? does the data

acquisition and post processing (if any), and puts the result in the Output

queue. Use this command combination to instruct the counter to perform

something between the measurement setup and data acquisition.

:READ[[:SCALar]:<function>]?

For more information about <function>, <parameters> and <source_list>, please

refer to the above table.

Using the command READ? has a same effect as using the command

INITiate[:IMMediate] followed by the command :FETCh?.

:READ

:READ[:SCALar]

[:VOLTage]:FREQuency?

[:VOLTage]:FREQuency:RATio?

[:VOLTage]:PERiod?

[:VOLTage]:RISE:TIME?

[:VOLTage]:RTIMe?

[:VOLTage]:FALL:TIME?

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 196 197

Sin comentarios

Bnc 1105 Universal Counter Manual de usuario Pagina 73