Bnc 1105 Universal Counter Manual de usuario descargar pdf (Pagina 74)

7474

[:VOLTage]:FTIMe?

[:VOLTage]:PWIDth?

[:VOLTage]:NWIDth?

[:VOLTage]:INITerval?

[:VOLTage]:PTPeak?

[:VOLTage]:MAXimum?

[:VOLTage]:MINimum?

[:VOLTage]:CENTer?

[:VOLTage]:PHASe?

[:VOLTage]:DCYCle?

[:VOLTage]:PDUTycycle?

[:VOLTage]:TOTalize:TIMed?

The Commands INITiate and FETCh?

These two commands provide the lowest level of control of measurement

triggering and reading retrieval, but offer the most flexibility. After you

have configured the universal counter, use the command INITiate to

initiate the measurements. The results are sent to the internal memory

and stored until you are ready to read them.

FETCh[[:SCALar]:<function>]?

For more information about <function>, please refer to the above table.

The command FETCh? sends the data in the universal counter’s internal

memory to the output buffer where you can read them into your bus

controller.

:INITiate

:AUTO<Boolean>

:CONTinuous<Boolean>

[:IMMediate]

:FETCh

FETCh[:SCALar]

[:VOLTage]:FREQuency?

[:VOLTage]:FREQuency:RATio?

[:VOLTage]:PERiod?

[:VOLTage]:RISE:TIME?

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 196 197

Sin comentarios

Bnc 1105 Universal Counter Manual de usuario Pagina 74